README.TXT                          	February 4, 1997

Diskeeper[R] Lite for Windows NT[R] V1.1.137 -- x86 Platform

This text file provides information you should know about this 
version of Diskeeper Lite.


IMPORTANT NOTE
==============

Service Pack 2 for Windows NT 4.0, which contains fixes for 
potential data corruption and many other fixes is now available 
at the following location:

ftp://ftp.microsoft.com/bussys/winnt/winnt-public/fixes

While we have not received any reports of file corruption in field test, 
we have found that applying this Service Pack has resolved some 
intermittent problems running Diskeeper.  Therefore, we strongly 
recommend applying this Service Pack to your Windows NT systems.  


A NOTE TO LAPTOP AND NOTEBOOK USERS
=================================

Diskeeper Lite is only supported at this time on laptop or notebook 
computers running Service Pack 2 for Windows NT 4.0.
 

KNOWN INCOMPATIBILITIES IN THIS RELEASE
=======================================

1.  Diskeeper for Windows NT is not compatible with systems 
    using the DPT Smart Cache III controller, unless Service 
    Pack 1 for Windows NT 4.0  has been installed.  Do not run 
    Diskeeper on systems using the DPT Smart Cache III controller 
    until you install Service Pack 1 on your Windows NT system.


PLATFORMS AND OPERATING SYSTEM VERSIONS SUPPORTED
=================================================

This version of Diskeeper Lite is supported on Intel x86 
platforms running Windows NT 4.0 builds 1381 and higher.  


REQUIRED PRIVILEGES
===================

You must have Administrator privileges to install and
operate Diskeeper Lite.


INSTALLING DISKEEPER LITE
=========================

Follow these steps to install Diskeeper Lite:

1.  From Windows NT Explorer or File Manager, double click on
    SETUP.EXE in the directory where this README.TXT file resides.

2.  Read the information displayed in the Setup Installation 
    Wizard boxes and click the "Next" button as appropriate.

3.  In the "Choose Destination Location" dialog box, either 
    accept the default installation location, or click the 
    "Browse" button to specify a different disk and/or 
    directory.  If you specify a directory that does not exist, 
    the setup program will create it for you.  Click the 
    "Next" button after specifying a disk and directory, or to 
    accept the default installation location.

4.  After a short period of copying files, the installation is 
    complete.


UNINSTALLING DISKEEPER LITE
===========================

Follow these steps to remove Diskeeper from your computer:

1.  From Control Panel, double click "Add/Remove Programs".

2.  Click the "Install/Uninstall" tab.

3.  Highlight "Diskeeper Lite".

4.  Click the "Add/Remove" button.  This removes the Diskeeper 
    program files from your computer.



(c) Copyright 1997 Executive Software International, Inc.  
    All rights reserved.

Diskeeper is a registered trademark owned by Executive 
Software International, Inc.

Windows NT is a registered trademark owned by Microsoft Corporation.

All other trademarks are the property of their respective owners.